skyrun
Active Member
I have several scheduled jobs that for the most part run without any issues. i have one job that has recently stopped running correctly (leaves state=2). when i run the job from the scheduled list (check and press 'run'), it works fine, but when it's running automatically, it doesn't complete and leaves the state at 2.
any tips on how to debug this?
i checked jos_fabrik_log and it shows the jobs as starting but no 'referring url' or 'message' there.
i turned display messages on also and i'm not getting any messages.
the job creates a .pdf report and then emails it. it runs in about 60 seconds. could there be a time out issue?
ALSO NOTE i'm on V2 (posted here since i don't think thre is a silver forum for v2)
any tips on how to debug this?
i checked jos_fabrik_log and it shows the jobs as starting but no 'referring url' or 'message' there.
i turned display messages on also and i'm not getting any messages.
the job creates a .pdf report and then emails it. it runs in about 60 seconds. could there be a time out issue?
ALSO NOTE i'm on V2 (posted here since i don't think thre is a silver forum for v2)